Modification and prototype test of staple gun
This paper presents how to design a staple gun and verify its data through simulation. The staple gun was estimated and analyzed using ‘ANSYS software and the results were compared with those obtained through experiments. In this research, a supporting position for the spring inside the staple gun was damaged after hundreds of loads, and there was no data about the impact force when staples were shot into the targets. Therefore, a prototype test system is developed to validate the data through simulation. In this case, the results are quite close to each other before they can be used to help the manufacturer to improve its structure. This prototype test system is completed through PC-based automation software. The simulation model was modified to develop the next new products for saving costs and time. Because the impact force, coming out from the staple gun is pretty large, it should be restricted within a certain limit to keep the user safe.
Nail gun (Staple gun) spring mechanism force sensor
Kuang-Yih Tsuei Gwo-Jen, Wu
Center for Measurement Standards/Industrial Technology Research Institute, CMS/ITRI, Bldg. 16,321 Ku Center for Measurement Standards/Industrial Technology Research Institute, CMS/ITRI, Bldg. 16, 321 K
国际会议
第五届仪器科学与技术国际学术会议(ISIST 2008)Fifth International Symposium on Instrmentation Science and Technology
沈阳
英文
1-5
2008-09-15（万方平台首次上网日期，不代表论文的发表时间）