Salt Bath Boronizing of a Fe-Mn-Al System Alloy: Wear and Corrosion Evaluation

摘要：

Fe-Mn-Al alloys have been studied with respect to their mechanical properties, behavior under oxidation, corrosion properties and phase transformations. In this study a Fe-Mn-Al alloy was produced using an induction furnace and bonded by salt bath immersion. Wear tests and potentiodynamic sea water corrosion tests were performed on samples with and without the boronizing treatment for the purpose of performance comparison. The boronizing treatment formed a high hardness layer on the sample and wear and corrosion resistance increased significantly.

关键词： Fe-Mn-Al boronizing wear corrosion

作者: Casteletti L.C. Heck S.C. Fernandes F.A.P. Totten G.E. Lombardi-Neto,A. Picon C.A.

作者单位: University of Sao Paulo,Sao Carlos,Brazil Portland State University,Portland,OR,USA AEROALCOOL,Franca,SP,Brazil State University of Sao Paulo,Ilha Solteira,Brazil

会议类型: 国际会议

会议名称: The Fourth Asian Conference on Heat Treatment and Surface Engineering(第四届亚洲热处理及表面工程大会)

会议地点: 北京

会议语种:英文

页码: 326-329

在线出版日期: 2009-10-27（万方平台首次上网日期，不代表论文的发表时间）