会议专题

Study on the Reverse Engineering Design of the Automobile Stamping Part of Using the ATOS Optical Measuring Techniques

With the development of the computer and measuring technology, the reverse engineering design of realization production by the CAD/CAM technology and the advanced manufacture technology became one of the main development trends in CAD/CAM researching field and the primary content of the application of the reverse engineering technology. In the paper, the whole reverse engineering design processing about a typical automotive stamping part –the front beam cover part was researched. The two key techniques of the reverse engineering technology: measuring and post processing were discussed. In particular, how to using the advanced optical measuring techniques by ATOS to measuring and building the 3D model of automobile part was presented at length.

RE (Reverse Engineering) ATOS Stamping Measuring Techniques

Gong hongying Ni li Sun yibing Yuan kai

The Dept.of Material Processing Engineering of Shanghai University of Engineering Science (201620)

国际会议

第八届国际测试技术研讨会(8th International Symposium on Test and Measurement)

重庆

英文

3057-3060

2009-08-01(万方平台首次上网日期,不代表论文的发表时间)