The Measurement of Abrasive Wear based on Computer Vision
To measure the height and wear of the diamond abrasive, a new technique based on computer vision is presented in this paper. Firstly, the computer vision system is designed. The height evaluation of abrasives and the calibration of the imaging set-up are introduced in detail. Secondly, we adopt the sequential similarity detection algorithm to get corresponding pixels in the left and right image. Finally, the heights and wear of the grain are obtained by calculating their parallax on left and right images. The experiment of standard block shows that the relative error is less than 5％.
computer vision monolayer grinding wheel height wear
Xiaofeng Zhang Bin Wan Jiexian Zeng
School of Computing Nanchang Hangkong University Nanchang P.R.China School of Computing, Nanchang Hangkong University Nanchang P.R.China
国际会议
Second International Symposium on Electronic Commerce and Security(第二届电子商务与安全国际研究大会)(ISECS 2009)
南昌
英文
748-751
2009-05-22（万方平台首次上网日期，不代表论文的发表时间）