会议专题

A New Approach for Friction Modeling at the Tool-Chip Interface in Orthogonal Cutting

A better understanding of friction modeling is really important for producing more realistic finite element models of machining processes. This paper presents a methodology to determine the friction at the tool-chip interface. By matching the measured values of the cutting forces with the predicted results from finite element simulations (FEM), a revised friction model on the tool-chip interface is developed. Reasonable distribution of the stress, strain and strain-rate, as well as the temperature fields at the tool-chip interface could be achieved by using this approach. An attempt is made by FEM to obtain a full understanding of relationships between the complex physical behavior and friction at the tool-chip interface. It is found that the sticking-sliding separated area is located at the points with the greatest temperature. And the corresponding relationship between cutting parameters and sticking-sliding friction separated area is found.

Friction model Tool-chip interface Sticking and sliding Orthogonal cutting

WANG Jiachun LI Na KOU Yunpeng YANG Yulin

College of mechanical engineering Yanshan University, QinHuangdao, 066004, China

国际会议

第九届加工技术进展国际会议(9th International Conference on Progress of Machining Technology)

昆明

英文

486-489

2009-04-25(万方平台首次上网日期,不代表论文的发表时间)