Bending Fatigue Characteristics of WC-βt-Co Alloys
WC-βt-Co alloys have been widely applied to cutting tools because they are superior to WC-Co alloys in oxidation, plastic deformation and adhesion resistances. In this study, the effects of HIP treatment, WC grain size and content of βt phase on bending fatigue characteristics were investigated for fine and coarse-grained WC-6.7mass％βt-10.4mass％Co alloys （6.7βt(F) and 6.7βt(C) alloys） and fine-grained WC-20mass％βt-11.3mass％Co alloy (20βt(F) alloy) by comparing with the case of fine-grained WC-10mass％Co alloy（10Co(F) alloy） without βt phase. The results obtained were as follows: 1) The bending fatigue life of HIP-ed 6.7βt(F) alloy was longer than that of normally sintered 6.7βt(F) alloy. The S-N curve of HIP-ed alloy showed a small gradient in a high stress range and a large gradient in a low stress range. 2) The fatigue life of HIP-ed 6.7βt(F) alloy remarkably decreased in the high stress range, but slightly decreased in the low stress range, compared with that of 10Co(F) alloy. 3) The fatigue life of HIP-ed 6.7βt(C) alloy was superior in all the stress range, compared with that of HIP-ed 6.7βt(F) alloy. 4) The fatigue life of HIP-ed 20βt(F) alloy was shorter than that of 6.7βt(F) alloy in all the stress range．The above-mentioned results were mainly discussed relating to the fatigue fracture origins such as pore, Co pool, agglomerate of βt grains, etc.
WC-βt-Co alloys bending fatigue life fatigue fracture origin Co pool agglomerate of βt
Kusuhiko Sakagami Shinichi Kouno Tsutomu Yamamoto
Dijet Industrial Co., Ltd., 2-1-18 Kamihigashi Hirano-ku, Osaka 547-0002 Japan
国际会议
第九届加工技术进展国际会议(9th International Conference on Progress of Machining Technology)
昆明
英文
15-18
2009-04-25（万方平台首次上网日期，不代表论文的发表时间）