Flank Milling for Blisk with a Barrel Ball Milling Cutter

摘要：

To satisfy the requirement in blisk machining, a barrel-ball milling (BBM) cutter suitable for machining both blade and hub is presented in this paper. The selection of cutter parameter and calculation of cutter location were put forward. The new efficient machining cutter location via the advanced optimization on cutter machining strip width was gained. By the numerical simulation of blisk blade machining, the feasibility of the BBM cutter and cutter location strategy were verified. The result showed that the efficiency of this method was increased to more than three times compared to the machining with a ball cutter.

关键词： Barrel ball milling cutter Flank milling Blisk Five-aizs machining.

作者: LI Tian CHEN Wuyi XU Rufeng WANG Dan

作者单位: School of Mechanical Engineering and Automation Beihang University, Beijing, 100191, China

会议类型: 国际会议

会议名称: 第九届加工技术进展国际会议(9th International Conference on Progress of Machining Technology)

会议地点: 昆明

会议语种:英文

页码: 202-206

在线出版日期: 2009-04-25（万方平台首次上网日期，不代表论文的发表时间）