Up-to-Date Measurement Devices for Continuous Casters
Continuous casting machines have to be adjusted properly to produce a high output with good quality. The tools to prove that start at the mold where the correct taper and width of the mold as well as the correct oscillation have to be checked. During casting, a mold monitoring system then shows the thermal and oscillation condition of the mold gives detailed analysis of the mold level and its surface and prevents breakouts. For the strand guidance, it is necessary to measure roll gap and roll rotation as well as segment alignment. Spray water of secondary cooling can be checked, too. The influence of all these measurements on the production of high quality is shown.
mold oscillation strand condition monitoring roll gap roll alignment spray water
Oliver Lang Christian F(u)rst Richard Sandner Stelvio Buoro
Vatron GmbH, Austria Voestalpine Stahl GmbH, Austria Acciaierie Venete S.p.A., Italy
国际会议
北京
英文
599-604
2008-11-04（万方平台首次上网日期，不代表论文的发表时间）