Burr Formation in Circular Cross Sawing of Western Hemlock
1 Introduction Although it is well known that burr formation occurs on the back surface of work material in circular cross sawing, there are few reports on this research subject. In this work, we conducted circular cross sawing of western hemlock by use of panel saw with tungsten carbide tipped saw. Effects of height of carbide tipped saw on the table of panel saw, fiber orientation on cutting plane, and tooth wear of tungsten carbide tipped saw on burr height were examined. Furthermore the burr height for western hemlock with those for other work materials was also compared.
Haruka YASUI Masayasu NAGAMATSU Kaoru BANSHOYA
Graduate School of Education, Hiroshima University, 1-1-1 Higashi-Hiroshima 739-8524 Japan
国际会议
International Symposium on Wood Science and Technology(IAWPS 2008)(国际木材产品学会联合会2008学术研讨会)
哈尔滨
英文
69-70
2008-09-27（万方平台首次上网日期，不代表论文的发表时间）