Design of Small Reconfigurable Embedded Numerical Control System

摘要：

The traditional numerical control system is independent and close. Different manufacturers are not compatible with each other which lead to much time and resources waste. A small reconfigurable numerical control machining center based on embedded microprocessor S3C2410 is implemented in the paper.Each module in the system is connected by standard interfaces which make it easy to reconstruct or expand.A general architecture of G codes interpreting under winCE4.2 and the method of embedded system to access external devices are discussed.

作者: Dianhong Wang Xiaoyong Ni

作者单位: School of Mechanical and Electronic,China University of Geosciences,Wuhan,China

会议类型: 国际会议

会议名称: The 2008 International Conference on Embedded Software and Systems Symposia(ICESS 2008)(2008国际嵌入式系统及嵌入式软件会议)

会议地点: 成都

会议语种:英文

页码: 415-421

在线出版日期: 2008-01-01（万方平台首次上网日期，不代表论文的发表时间）