Virtual Design and Simulation in New Produt Development of Automobile Sunroof
In this paper the reverse engineering and Software Catia were applied to create the 3D digital model. Then the model was imported into ADAMS to build the virtual prototype. After that the key components which affect the movement characteristics of the sunroof were abstracted out to build the kinematic model. Then the virtual assembling, kinematics simulation and analysis were done wi ADAMS software. Finally, a parameter optimization was done based on the study result of the simulation and analysis. The study in this paper can not only improve the design quality and development efficiency of new automotive sunroof productions, but also remarkably shorten the Production development period and reduce the development cost.
Sunroof Production development Virtual Design Simulation and Analysis
Xiaoxia Xu Yu Ning Yingchun Han
Department of Industrial Design, Jilin University, Changchun, China;School of Mechatronic Engineerin Department of Industrial Design, Jilin University, Changchun, China;the First Automobile Workshop Gr Department of Industrial Design, Jilin University, Changchun, China
国际会议
昆明
英文
354-358
2008-11-22（万方平台首次上网日期，不代表论文的发表时间）