会议专题

A Simplified Calculation Method for Estimating Heat Flux from Ceiling Radiant Panels

In this paper,we have developed a calculation method for estimating heat fluxes from ceiling radiant panels,using pipe density on panels and the temperature difference between the room air and the supply water.We then measured heat fluxes from panels in an environmental test room.After comparing the values estimated by our calculation method to the experiments data,the calculated values closely match the values obtained from experiments,which means that this calculation method is practical in estimating the radiant panel performance in the design phase.

Ceiling radiant panels Calculation method Pipe density on panel Surface temperature measurements Radiant and convective heat flux

Shigeru Okamoto Hisataka Kitora Hiromasa Yamaguchi Tatsuo Oka

Environmental Planning Section,Tohata Architects & Engineers,Inc.,Osaka,Japan Civil Engineering and Building Section,Kansai Electric Power Co.,Inc.,Osaka,Japan Dept.of Architecture,Faculty of Engineering,Utsunomiya University,Utsunomiya,Japan

国际会议

The First International Conference on Building Energy and Environment(第一届建筑能源与环境国际会议)

大连

英文

1460-1468

2008-07-01(万方平台首次上网日期,不代表论文的发表时间)