Effect of Grinding Conditions on Energy Consumption in Cement Production
In this investigation, one of the most energy consuming stage of the cement manufacturing process, grinding stage, was studied. The aim of the study is to reduce the energy consumption. Optimum operating parameters were determined. Experimental studies were performed at three different stages. Grinding of limestone, clay and marl which are the main components of the cement, to approximately below 90 microns, was the first stage of the cement grinding. At this stage, effect of feed size and ball charge were investigated.At the second stage, the Bond work index of clinker and additives (slag, trass, limestone and gypsum) was found separately. After forming composite cement with clinker and additives, the Bond work index of this mixture was also determined, thus the results of separate grinding and grinding of mixture were compared. The Bond work index of mixture was found as 13.59 kWh/t,while the arithmetic mean of the Bond work index values of components was 14.90 kWh/t.Finally, clinker and additives (slag, trass, limestone and gypsum) were ground under the same conditions. At this stage, laboratory type of ball mill was used in order to understand grinding characteristics of the cement components.As a result of the experiments, it was found that energy consumption for the grinding will be lowered if the mills with 38 %～40 % ball charge are used in the cement grinding. Moreover,grinding with mixture of clinker and additives gave better results than separate grinding of these components in terms of energy consumption.
Grinding Cement Additive Energy consumption
F. Karakas G.(O)nal
Istanbul Technical University, Mineral Processing Department, Turkey
国际会议
XXIV International Mineral Processing Congress(第24届国际矿物加工大会)
北京
英文
257-261
2008-09-24（万方平台首次上网日期，不代表论文的发表时间）