Model-Based Development Architecture for Embedded CNC System

摘要：

Current development method for Computerized Numerical Control (CNC) system is mainly based on manual programming,so it is very time- consuming and is difficult to guarantee system performance.This paper presents a model-based development architecture,which is based on meat-model and model transformation,to address the problem.A domain-specific meta-model has been created to establish a special modeling environment for CNC system.In this modeling environment,different implementation models may be constructed according to different system requirements.These models can be translated into third- party simulation tool by model translators so that they can be analyzed and validated.Models interpreters are used to generate source code automatically from models to produce executable system.This development architecture can promote development efficiency,reduce development cost and improve system stability.

关键词： meta-model model interpreter CNC

作者: Zhaogang Shu Di Li Feng Ye Suhua Xiao

作者单位: School of Automation, South China University of Technology, Guangzhou,Guangdong province,China.51064 School of Mechanical Engineering, School of Mechanical Engineering, South China University of Techno School of Mechanical Engineering, South China University of Technology, Guangzhou,Guangdong province

会议类型: 国际会议

会议名称: 2007 IEEE International Conference on Automation and Lofistics

会议地点: 山东济南

会议语种:英文

在线出版日期: 2007-08-18（万方平台首次上网日期，不代表论文的发表时间）