会议专题

Calculation of Cu-rich part of Cu-Ni-Si phase diagram

The thermodynamic calculation of phase equilibria in the Cu-Ni-Si alloy system was carried out using the CALPHAD method.The calculations show that there are three two-phase areas and two three-phase areas in the Cu-rich parts of the isothermal section of the phase diagram at 300.600 ℃ ,and the three two-phase areas are FCC-A1(Cu-rich)+γ-Ni5Si2,FCC-A1(Cu-rich)+δ-Ni2Si and FCC-A1(Cu-rich)+ε-Ni3Si2,two three-phase areas are FCC-A1(Cu-rich)+γ-Ni5Si2+δ-Ni2Si and FCC-A1(Cu-rich)+δ-Ni2Si+ε-Ni3Si2.For this reason,an alloy located in the Cu-rich portion may precipitate γ-Ni5Si2,δ-Ni2Si or ε-Ni3Si2; the proportion of each phase depends on the alloy composition and aging temperature.The transmission electron microscope analysis of the Cu-3.2Ni-0.75Si alloy indicates that the precipitates are mainly δ-Ni2Si with only a few γ-Ni5Si2 phase particles,which agrees well with the thermodynamic calculations of phase equilibria.

Cu-Ni-Si alloy phase diagram calculation thermodynamics

LU De-ping WANG Jun A.Atrens ZOU Xing-quan LU Lei SUN Bao-de

Institute of Applied Physics,Jiangxi Academy of Sciences,Nanchang 330029,China State Key Laboratory of Metal Matrix Composite,Shanghai Jiao Tong University,Shanghai 200030,China Division of Materials,The University of Queensland,Brisbane,Qld,Australia 4072

国际会议

2007年国际有色金属大会(International Conference of Nonfereous Materials 2007)(ICNFM)

长沙

英文

2007-11-28(万方平台首次上网日期,不代表论文的发表时间)