Effect of spray forming on evolution of microstructure and mechanical behavior of Mg-9Al-1Zn alloy
(0) The cylindrical billet of Mg-9Al-1Zn alloy was produced by spray forming and hot extruded at 698.723 K with an extrusion ratio of 22?.The microstructural evolution was investigated systematically.The mechanisms of grain refinement,solubility extension of Al and Zn elements in Mg matrix,and the precipitation of the second phase .-Mg17Al12 as well as their effect on the mechanical properties of the Mg-9Al-1Zn alloy were analyzed and discussed.The results show that the spray formed Mg-9Al-1Zn alloy has homogeneous equiaxed fine grains with the average grain size of 17 祄,of which the average grain size is refined further to 5 祄 due to dynamic recrystallization during hot extrusion process.The evolution of size,proportion and distribution of .-Mg17Al12 phase was also observed and analyzed.The mechanical properties for the extruded rods are improved remarkably at ambient temperature.
Mg-9Al-1Zn alloy magnesium alloy spray forming microstructure mechanical property
YU Hong-yan HUANG Jin-feng LI Yong-bing CUI Hua HE Jian-ping ZHANG Ji-shan
State Key Laboratory for Advanced Metals and Materials,University of Science and Technology Beijing, School of Materials Science and Engineering,University of Science and Technology Beijing,Beijing 100
国际会议
2007年国际有色金属大会(International Conference of Nonfereous Materials 2007)(ICNFM)
长沙
英文
2007-11-28（万方平台首次上网日期，不代表论文的发表时间）