Modeling of Material Removal Rate in Two-dimensional Ultrasonic Grinding Complex Ceramics
Based on the machining pattern, mechanics of material removal and theory of micro-indentation, in previous studies the models of material removal rate of hard- brittle materials was discussed through the relatively influencing factors of machining parameters from various aspects, reflecting the research advances on mechanics of material removal of hard-brittle materials. However, those models of material removal rate have limitations, which results from impercipient theory of fracture of new kinks of materials, randomicity of practical machining process, inappropriate assumptions and simplification of the machining conditions and so on. In this work firstly, previous models of material removal rate of hard-brittle materials machining with ultrasonic assistance were reviewed briefly. Subsequently, the models of material removal rate of complex ceramics machining with two-dimensional ultrasonic vibration assistance were established based on fracture theory of micro-indentation in fracture regime and plastic removal mechanics in ductile regime respectively. The material removal rate is affected not only by the properties of material and machining parameters, but also by the character of grinding wheel and parameters of ultrasonic vibration
Material removal rate Ultrasonic grinding Two-dimensional vibration Complex ceramics
Guofu Gao Bo Zhao Qinghua Kong Chuanshao Liu
Mechanical and Power Engineering Department, Henan Polytechnic University, Jiaozuo, China Mechanical Mechanical and Power Engineering Department, Henan Polytechnic University, Jiaozuo, China Mechanical Engineering Department, Tongji University, Shanghai, China
国际会议
第14届全国磨粒技术学术会议(14th Conference of Abrasive Technology in China)
南京
英文
431-435
2007-10-26（万方平台首次上网日期，不代表论文的发表时间）