Effection of Alloying Elements on Microstructures of MX 246 and MX 246A Ni3Al-Based Alloys
The effects of alloying elements on microstructure of two compositions of Ni3Al-based alloys, MX 246 and MX 246A have been studied in this article. The results show that starburst γ-γ eutectic phases are large and their amount is about 18％ in MX246. Majority NiZr and a little of ZrC are formed in the boundaries of γ-γ eutectic phases.Microstructure at 1200℃ shows that NiZr phases have been melted completely, which cause the decrease of melting point of γ phases to about 1125℃. With increasing alloying additions such as Mo and Hf, γ-γ eutectic phases are dispersive, uniform, small, and their amount is decreased to about 4％. Carbides and borides are formed in MX246A.The volume fractions of the phases in MX246A and the chemical compositions of the phases have been quantitatively analyzed. The results show that carbides and borides are about 1.12％ in MX246A and the main carbides are TiC, HfC and the borides are (Ni0.086Cr0.087W0.094Mo0.376Ti0.334 Hf0.024) 3B2. TEM observation results show that with increasing alloying element additions such as Mo and Hf, a lot of γ/γ interface misfit dislocations are produced in the interface of γ and γ phase and they are interacted with the nanometer γ particles. γ phases are all stable in MX246A at1200℃. The stability of γ phase is increased with the addition of Mo and Hf. In addition, there are many white spot phases which are mainly NiMo phases, and a little (NiMo)6C and (MoTi)6C gathering in some interdendrite areas.
Ni3Al microstructure alloying element
ZHANG Xi-e LUO He-li LI Shang-ping CAO Xu LI Shi-qiong
China Iron and Steel Research Institute Group, High temperature Material Research Institute, Beijing, 100081, China
国际会议
北京
英文
45-52
2007-09-18（万方平台首次上网日期，不代表论文的发表时间）