COMPARING THE EFFICIENCY OF FIXED SOLAR CELL PANELS IN A TROPICAL LOCATION
Monocrystalline, polycrystalline and amorphous silicon solar cell panels were installed side-by-side on the same fixed rig to determine the relative performance in a tropical location. This study was conducted at Nakhon Ratchasima Rajabhat University, Thailand. The fixed panel rig was positioned at a tilt angle of 30o, facing south. Overall performance of the solar cell panels is given via both annual output and an average conversion efficiency over one whole year. The results show that for a fixed orientation the monocrystalline, polycrystalline and amorphous panels, had average conversion efficiencies of 6.8％±2.4％, 5.7％±2.0％ and 4.2％±1.5％ respectively in terms of total incident solar energies on the plane of cells which were 809.4 kW·a/m2, 860.8 kW·a/m2 and 820.6 kW.year/m2 respectively. The uncertainties shown represent the standard deviation in the conversion efficiencies determined over the 12 month period of the study. These conversion efficiencies are lower than expected but are in part due to local conditions and their significant impact on movements in the maximum power point, which was not tracked in these fixed load experiments. This study also examined the effects of ambient air temperature and wind speed close to the panels which in this locale had very little impact on conversion efficiency. A detailed economic analysis was then carried out including relative maintenance costs. In terms of return on investment the panels ranked in their performance order; fixed monocrystalline, then polycrystalline and finally amorphous but the overall economics was not attractive and significant system cost reductions are needed.
Pattanapong Jumrusprasert Geoff Smith Leslie Kirkup
Physics and Advanced Materials Department Faculty of Science University of Technology, Sydney, NSW P.O.Box 123 Sydney 2007, Australia
国际会议
2007世界太阳能大会(Proceedings of ISES Solar World Congress 2007)
北京
英文
2007-09-18（万方平台首次上网日期，不代表论文的发表时间）