MINIMISATION OF POWER LOSS FROM PARTIALLY SHADED SOLAR CELL ARRAYS
In conventional wiring schemes the output from a partially shaded solar cell array drops rapidly to that of the fully shaded array even when only a small fraction is shaded. In this paper circuit simulation has been used to show that by dynamically reconfiguring the array, the power losses due to shading can be significantly reduced. Reconfiguration is achieved by using switching microcircuits with on-chip photo detectors to determine which parts of the array are in shade. The currents from the shaded and unshaded sections of the array are separated and then connected in parallel to a maximum power point tracker. It is shown that by using this reconfiguration that the power output from a partially shaded array can be increased by at least 100％ compared with that from a conventional series connected array over a range of shading conditions.
Tony Maine Stewart Martin John Bell
Built Environment Engineering, Queensland University of Technology, Gardens Point, Brisbane 4000, Au School of Electrical and Information Engineering, University of South Australia, Mawson Lakes Campus
国际会议
2007世界太阳能大会(Proceedings of ISES Solar World Congress 2007)
北京
英文
2007-09-18（万方平台首次上网日期，不代表论文的发表时间）