STATIC ANALYSIS OF DESICCNAT WHEEL 2ND REPORT: PERFORMANCE ANALYSIS AND OPTIMUM DESIGN OF THE DESICCANT WHEEL
In the 1st report, the steady state simulation model of the desiccant wheel was built and the validity of this model was comfirmed by comparing the simulation results with the experimantal ones.In this paper ,as the 2nd report, the optimum design method to minimize the volume of the desiccant wheel is discussed using the steady state simulation model we described in the 1st report.Firstly, effects of the system parameters on the volume of the desiccant wheel is investigated to reveal that the system parameters have the optimum points to minimize the volume of wheel.Secondly, the optimum solution under the given design conditions are searched.Finally, effects of the design conditions on the minimum volume of the desiccant wheel is investigated.As a result, we found that both the rotary speed and the regeneration side area ratio have the optimum points to minimize the volume of the wheel. However, the radius of the desiccant wheel doesn’t have the optimum point. Moreover, effects of the design conditions such as air inlet conditions on the minimum volume of desiccant wheel were clarified.
S.YAMAGUCHI K.SAITO S.KAWAI M.OKA T.MURAKAMI H.SASAKI
School of Fundamental Science and Engineering, Waseda University, 3-4-1, Okubo, Shinjuku-ku,Tokyo,16 Solution Technology Dept., Tokyo Gas Co., 7-1-3, Nishishinjuku, Shinjuku-ku, Tokyo,116-0003 Japan
国际会议
The 22nd International Congress of Refrigeration(第22届国际制冷大会)
北京
英文
2007-08-21（万方平台首次上网日期，不代表论文的发表时间）