Characterization of the CuCrZr alloy and the Cu/ss joints for ITER first wall
As the ITER first wall material, Cu-alloy should satisfy the ITER specification for the material. The alloy would be influenced not only by thermo- mechanical process but also by the neutron radiation. It is thus necessary to study the effect of heat treatment on the microstructure and mechanical properties of the alloy. Besides, as a heat sink material, the alloy would be bond to a support back plate of 316LN steel in the FW panel. Mockups of Cu/ss joints have been fabricated by a hot isostatic pressing (HIP) process. The interface needs to characterize to understand the bonding mechanism. According to the material specification for the supply of CuCrZr-ITER Grade alloy plates for the ITER First Wall, CuCrZr alloy was prepared by vacuum melting. Ingots were then forged and hot-rolled to 13-18mm thick plate. Samples were cut from the plates. They were solid solution annealed at 960- 1040℃ for 30 minutes, followed by aging at 475℃ and 580℃. Tensile tests were conducted at RT and 250℃. The microstructure of the alloy were analyzed. Results showed the significant effect of the heat treatment on the microstructure and the tensile strength. For the Cu-SS joining, the HIPing method showed promising. Bonding strength was measured by tensile test at RT and the interface was observed by SEM. No defects at the interface were found by optical microscope and SEM observation. However, the grain of Cu-alloy in the vicinity of interface are inhomogeneous, fine grain near the interface but very large ones in the faraway area. EDS analysis shows the change of alloy element content and microstructure across the interface.
D. H. Liu J. H. Wu P. F. Zheng D. S. Yan J. M. Chen
Southwestern Institute of Physics, P. O. Box 432, Chengdu 610041, China Institute of Metal Research, Chinese Academy of Sciences, Shenyang, China
国际会议
桂林
英文
335-339
2007-10-23（万方平台首次上网日期，不代表论文的发表时间）