High Pressure Heat Treatment-Optimized Material Properties by HIP

摘要：

　　An investigation of HIP parameters for EBM Ti-6Al-4V has been performed with the aim to maximize the strength of the HIPed material.A lower HIP temperature of 800℃ and a higher pressure of 200 MPa gives the highest strength and is also enough to eliminate all internal defects.By printing material with intentionally induced porosity combined with an optimized HIP cycle the highest strength can be obtained.

作者: Eklund Anders Ahlfors Magnus Bahbou Fouzi

作者单位: Quintus Technologies AB,Quintusv(a)gen 2,SE-721 66 V(a)ster(a)s,Sweden Arcam AB,Kroksl(a)tts Fabriker 27A,SE-431 37 M(o)lndal,Sweden

会议类型: 国际会议

会议名称: 2018世界粉末冶金大会

会议地点: 北京

会议语种:英文

页码: 377-381

在线出版日期: 2018-09-16（万方平台首次上网日期，不代表论文的发表时间）