Design and Optimization of Axial Position Sensing System in Maglev Blood Pump
The position sensing system is one of the most important parts in maglev artificial heart pump. This paper describes a newly developed axial position sensor system. The position sensing system is designed to be combined with the radial permanentmagnetic bearing and used for the control of the axial active magnetic bearing. The rotor ring of the radial magnetic bearing is used as field source, which shortens the rotor and saves space for maglev blood pump design. Linear hall sensor is selected due to its low cost and miniature size. The principle of the position sensing system is based on the analysis of the magnetic field of the permanent magnetic bearing and the sensor module is designed via finite-element analysis to optimize sensitivity and accuracy of the measured signals. An applied primary amplifier circuit for the position sensing is designed and its performance is tested. The experimental results demonstrate that the position sensing system has a satisfactory performance and is effective for axial control.
Maglev Blood Pump Permanent Magnetic Bearing Hall Sensor Position Sensing
Zhang Yunpeng Liu Shuqin Guan Yong Fan Youpeng
School of Electrical Engineering, Shandong University, Jinan, 250014, China
国际会议
The Twelfth International Symposium on Magnetic Bearings(第十二届国际磁悬浮轴承学术会议)
武汉
英文
109-117
2010-08-22（万方平台首次上网日期，不代表论文的发表时间）